Art. No. SC 1000 KNX
Figure 10: Example of a favourite page (4-gang display grid with selection operation)
The room page
Each KNX channel must be allocated to a room (area of operation). Channels can be operated
and visualized room-oriented via the room page. All rooms (1...8) that were created in the ETS
PlugIn are available on the room page. Each room has a sensor surface that can be touched.
The room-oriented submenus are recalled by touching the sensor surface (see page 70). The
rooms are each identified in the sensor surface by the name that was entered individually in the
ETS (e.g. "living", "sleeping" "bath").
4 rooms are always displayed simultaneously on the room page. If more than 4 rooms are
configured, the room list can be switched by the sensor surfaces
X
/
Y
or alternatively by a
vertical movement of your finger. If there are less than 4 rooms, placeholder surfaces without
names are displayed for the rooms that have not been created. These placeholder surfaces
have no function.
The room page is always visible in the main menu level. At least one room has always been
created.
i
A KNX channel is allocated to a room in the parameter node of the corresponding channel.
The channels can normally be allocated to one of the maximum 8 rooms. Hence, it is also
possible to allocate a channel to a room which is not visible on the room page, because it
was not created in the configuration of the rooms in the parameter node "Display ->
Rooms". In this case, the KNX channel concerned cannot be accessed via the room page!
It is generally recommendable to assign KNX channels only to rooms that are also
available in the room configuration.
Page 65 of 347
Software "Smart Control 501511"
Functional description
