Art. No. SC 1000 KNX
This parameter specifies whether the
first switching time is enabled or
disabled. Only active switching times are
executed. Inactive switching times in the
ETS can subsequently be activated on
the device after commissioning.
Similarly, activated switching times can
subsequently be deactivated on the
display pages of the switching times by
means of ETS.
Switching time hour
0...
8
...23
The switching time is specified here.
This parameter defines the hours
(0...23 / 24h-format) of the switching
time event.
Switching time minute
0
...59
The switching time is specified here.
This parameter defines the minutes
(0...59) of the switching time.
For the switching times preset in the
ETS to be correctly transferred to the
device during a programming operation,
the parameter "Overwrite timer
parameter" in the parameter node
"Display" must be set to "Yes". Before
putting into operation for the first time,
this parameter should be set to "Yes".
Otherwise, the switching times preset in
the ETS are not transferred to the
device.
Monday
not active
active
This parameter specifies whether the
switching time event is to take place on
Mondays. In the "active" setting, the
weekday of the switching time is
assigned.
Tuesday
not active
active
This parameter specifies whether the
switching time event is to take place on
Tuesdays. In the "active" setting, the
weekday of the switching time is
assigned.
Wednesday
not active
active
This parameter specifies whether the
switching time event is to take place on
Wednesdays. In the "active" setting, the
weekday of the switching time is
assigned.
Thursday
not active
active
This parameter specifies whether the
switching time event is to take place on
Thursdays. In the "active" setting, the
weekday of the switching time is
Page 280 of 347
Software "Smart Control 501511"
Parameters
