Art. No. SC 1000 KNX
This parameter is only visible when a
status text with unit text is to be
displayed.
Surface evaluation
Button function (single
surface)
Display function
In the function "2-byte value transmitter",
the sensor element is always executed
as a push-button function and does not
distinguish between any short and long
operations. As an alternative to the
operating function, it is possible to
deactivate the sensor surface in the
ETS. To do this, set this parameter to
"Display function". In this case, the
channel concerned only works as a
display function for value visualization.
Consequently, touching the sensor or
display elements does not induce any
response.
Value on pressing the
button
-671088.64...
0.0
...670760.96
This parameter defines the value
transmitted to the bus on pressing the
sensor surface via the object "2-byte
value transmitter". The value that the
user enters in the entry field is converted
by the ETS PlugIn to the KNX data type
9.0xx (floating-point numbers) and
written in the ETS database. This can
result in value adjustments due to
rounding.
The value transmitted via the
communication object of the channel
during an operation can vary from the
ETS preset value because a gain factor
and value offset can be configured
optionally (see "Gain" and "Offset").
This parameter is only visible when the
"surface evaluation" is configured to
"Button function (single surface)".
Activate keyboard after
a long press on status
value
Yes
No
In addition to the possibility of recalling a
value programmed by the ETS, a
keyboard can optionally be shown in the
display. It is possible to specify a value
directly using the keyboard and thus to
permanently vary from the value
configured in the ETS. The keyboard
becomes visible by pressing your finger
on the display area (long press approx.
1s) if this was also enabled here
(setting: Yes). Using the keyboard, a
value can be entered numerically. It
should be noted that only values within
the "Minimum value" and "Maximum
value" limits defined by the ETS
parameters can be entered. After
applying the value, it is transmitted to
the bus and saved permanently in the
device memory. Only an ETS
programming operation resets the value
to the ETS configuration.
Page 268 of 347
Software "Smart Control 501511"
Parameters
