Jung Smart Control SC 1000 KNX, Product Documentation

Page: 267 / 347

Art. No. SC 1000 KNX
Activate keyboard after
a long press on status
value Yes
No
In addition to the possibility of recalling a
value programmed by the ETS, a
keyboard can optionally be shown in the
display. It is possible to specify a value
directly using the keyboard and thus to
permanently vary from the value
configured in the ETS. The keyboard
becomes visible by pressing your finger
on the display area (long press approx.
1s) if this was also enabled here
(setting: Yes). Using the keyboard, any
value defined by the "Function"
parameter within the range (0...255" / "
0...100%") can be entered numerically.
After applying the value, it is transmitted
to the bus and saved permanently in the
device memory. Only an ETS
programming operation resets the value
to the ETS configuration.
If the setting is "No", a long operation of
the display area shows no response.
This parameter is only visible when the "
surface evaluation" is configured to "
Button function (single surface)".
The following parameters are only visible for the function "Value transmitter 2 byte"...
Icons no icon
Icon 1: Brightness
Icon 2: Temperature
Icon 3: Air humidity
Icon 4: Air pressure
Icon 5: Limiting value
An icon can be displayed in the lower
area of the channel display element.
This parameter defines which type of
status icon is used in the display
element. The icons of the 2-byte value
transmitter are static and do not change
their appearance.
The icon can be omitted optionally in the
display (setting: no icon).
Displaying status value Yes A status value is displayed below the
text name, which displays values in plain
text ("e.g "45%rF"). depending on the
object value of the value feedback of an
actuator. The status value is always
visible.
After a device reset, the display
shows "---" (possibly supplemented by a
unit) until a feedback object value of the
status text is received.
Displaying unit text Yes
No
The status text in the display can
optionally be supplemented by a unit.
The text for the value unit ("%rF" for
example) is specified by the parameter
"Text for unit".
Text for unit °C , free text with a max. of
5 characters
This parameter specifies the unit for the
status text. A text with a maximum of 5
characters can be entered.
Page 267 of 347
Software "Smart Control 501511"
Parameters