Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 51 / 300

49
Press button (4) fig. 82 to activate
heated rear window demisting/defrosting.
Whenever the ignition device switches
to the position 2 or the STOP START
ENGINE button is on START position,
the function switches off automatically
after approx. 10 minutes the first time
it is activated. The following activations
have a duration of 5 minutes.
If this function is provided, pressing
the button
MAX also activates
demisting/defrosting of door mirrors and
heated vents (where provided).
WARNING Do not apply stickers to the
inside of the heated rear window over
the heating filaments, to avoid damage
that might cause them to stop working
properly.
SWITCHING THE CLIMATE
CONTROL SYSTEM OFF/ON
Switching off the climate control system
Press the OFF button (9) fig. 82.
With climate control system off:
air recirculation is on, thus isolating
the passenger compartment from the
outside
the compressor is off
the fan is off
the heated rear window can be
activated/deactivated
The climate control system control unit
stores the temperatures set before the
system was switched off and restores
them when any button of the system is
pressed.
Switching on the climate control system
To switch on the climate control system
in fully automatic mode press the AUTO
button (2) fig. 82 or (4) fig. 83.
HEATER
The heater activates automatically
depending on the environmental
conditions and with ignition device in
the position 2 or with the STOP START
ENGINE button in position START.
SEAT HEATING
To open the page for setting the seat
heating levels press (5) fig. 83.
OPERATING LIMITS
With the car in "TURTLE" mode, climate
control limitations are automatically
introduced to preserve the range.
TEMPERATURE PRE-
CONDITIONING
(Electric versions)
This function allows you to programme
the temperature in the passenger
compartment to reach a pre-defined,
non-modifiable temperature (approx.
21
°
C) before you enter the vehicle, on
the days and at the times of your choice.
This function is available when the
vehicle is connected or not connected.
Programming
Press the button (5) fig. 82 to open
the Climate touch screen application
on the Uconnect™ 10.25"/10.25" NAV .
Select the Preconditioning tab
press + to add a programme
select the time of entry into the
vehicle and the desired days. Press OK
press ON to activate this programming
The pre-conditioning sequence begins
approximately 45 minutes before the
programmed time when the vehicle is
connected (20 minutes when it is not
connected) and is maintained for 10
minutes after.
NOTE You can set multiple programmes.
Each one is saved in the system.
To optimise the driving range, we
recommend starting a programme while
the vehicle is connected.
The programming can also be carried out
from a smartphone via the JEEP® app.
NOTE The fan noise that occurs during
temperature pre-conditioning is perfectly
normal.