Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 236 / 300

SERVICING AND MAINTENANCE
234
132) Before topping up or changing the
engine oil, check that the oil is suitable
for your engine and complies with the
recommendations in the service schedule
supplied with the vehicle (or available
from your Jeep Dealership). Use of non-
recommended oil may invalidate your
warranty in the event of engine failure.
133) Be careful not to confuse the various
types of fluids while topping up: they are
not compatible with one another! Topping
up with an unsuitable fluid could severely
damage your vehicle.
134) An excessive or insufficient amount
of oil inside the base is extremely
damaging to the engine. Make sure it is
always at an adequate level.
135) Overfilled engine oil must be drained
or suctioned out. If the oil exceeds the
maximum level, do not start the vehicle
and contact a Jeep Dealership.
136)
Filling with pure water is prohibited
in all circumstances (risk of freezing,
limescale, etc.).. Only washer fluid with
a sufficient antifreeze concentration
provides protection at low temperatures or
a sudden drop in temperature.
137) Using transmission fluid different
from that approved may compromise the
quality of gear changes and/or cause
vibration of the transmission.
138)
Attach the wiper blade to the inner
position of the wiper arm and push until it
engages.
139) Always require the use of only
compressor coolants and lubricants
approved and suitable for the specific
air conditioning system fitted on the
car. Some non-approved coolants are
flammable and may explode, with the risk
of injuries. The use of non-approved
coolants or lubricants may adversely
affect system efficiency, leading to
expensive repairs.
140) The air conditioner system contains
coolant under high pressure: to avoid
injuries to people or damage to the
system, any coolant addition or repair that
requires to disconnect the cables must be
carried out by a Jeep Dealership.
141)
Vehicles equipped with catalytic
converter must be fuelled only with
unleaded petrol. Leaded petrol would
permanently damage the catalytic
converter and eliminate its ability to
reduce polluting emissions, seriously
compromising the engine performance,
which would be irreparably damaged.
If the engine does not work correctly,
especially if it starts irregularly or if
there is a reduction of its performance,
immediately go to a Jeep Dealership.
Prolonged and faulty operation of the
engine may cause overheating of the
converter and, as a consequence, possible
damage to the converter and the vehicle.
IMPORTANT
7) Do not discard used oil or fluids
into sewers or onto the ground. Empty
used oil into the containers reserved for
this purpose at a dealer or a qualified
workshop.
JACKING POSITIONS
Before positioning the jack, take care
to remove the cover in the lifting point
fig. 312 by acting on the fastening
buttons using a special tool (screwdriver)
contained in the equipment of the car.
After removing the jack, be sure to
reapply the cover.
312
JJ000402
The jacking positions shown refer to the
use of lifting arms and accessory jacks
used for changing winter / summer tyres.
313
JJ000533
Rear arm position of the lifting platform
centrically under the relevant vehicle