Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 143 / 300

141
STEERING-MOUNTED
CONTROLS
_
182
JJ000759
(1) Activation of cruise control in
progress. Use the speed suggested by
the Traffic Sign Recognition
(2) Increase/Decrease the speed setting
(if cruise control activated). Activation
of cruise control in progress (if cruise
control deactivated)
(3) Cruise control ON/OFF
(4) Switch on/pause cruise control at the
previously saved speed setting
SWITCHING ON/PAUSING
Press button (3) fig. 182 to select
the cruise control mode; the function is
paused (grey)
press (2) upwards/downwards, or press
(1) OK to activate the cruise control
and save a speed setting as soon as the
vehicle speed reaches the desired level
(green)
pressing button (4) temporarily pauses
the function
pressing (4) or (1) OK again will
reactivate cruise control (green).
Cruise control operation is also
temporarily interrupted (pause):
by pressing the brake pedal
automatically, if the electronic
stability control (ESC) system is triggered
by shifting to neutral or engaging
reverse gear
by using the electric parking brake
NOTE You can temporarily exceed the
speed setting by pressing the accelerator
pedal (the programmed speed flashes).
To return to the speed setting, release
the accelerator pedal (when the set
speed is reached again, the displayed
speed stops flashing).
MODIFYING THE SPEED SETTING
The cruise control must be active.
To change the speed setting using the
vehicle’s current speed:
for steps of +/- 1 km/h (1 mph), make
successive short presses upwards/
downwards on (2) to increase/decrease.
for steps of +/- 5 km/h (5 mph), press
and hold upwards/ downwards on (2) to
increase/decrease.
WARNING Prolonged pressing and
holding upwards/downwards on 3 causes
a very rapid change in vehicle speed.
WARNING As a precaution, we
recommend setting a cruise speed
fairly close to the current speed of your
vehicle, to avoid any sudden acceleration
or deceleration of the vehicle.
When the function is activated, it is
possible to change the speed setting
using the speed suggested by the Traffic
Sign Recognition function (where
provided) displayed on the instrument
panel:
When passing the sign:
press (1) OK to save the
suggested speed. This value is then
immediately shown as the new
speed setting on the instrument
panel
After passing the sign:
Press (1) OK. The message "OK?"
fig. 183 is displayed to confirm the
request to save
Press (1) OK again to save the
suggested speed. The new speed
setting value is displayed on the
instrument panel
183
JJ000611