Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 233 / 300

231
wheel, may be temporarily unavailable
in the event of electrical loading
constraints. Functions will be resumed
after some minutes.
ELECTRIC PARKING BRAKE
This system does not require any routine
servicing. However, in the event of a
problem, do not hesitate to have the
system checked by a Jeep Dealership.
For more information on the Electric
parking brake, refer to the "Parking
brake" chapter in "Starting and driving"
section.
SHOCK ABSORBERS
It is not easy for drivers to detect when
shock absorbers are worn. Nevertheless,
the shock absorbers have a major
impact on road holding and braking
performance. For your safety and driving
comfort, it is important to have them
regularly checked by a Jeep Dealership.
TIMING AND ACCESSORY KITS
The timing and accessory kits are used
from the time the engine is started until
it is switched off. It is normal for them to
wear over time.
A faulty timing or accessory kit can
damage the engine, rendering it
unusable. Observe the recommended
replacement frequency, stated in
distance travelled or time elapsed,
whichever is reached first.
MANUAL GEARBOX
The gearbox does not require any
maintenance (no oil change).
ELECTRIC DRIVE UNIT
137)
Special additives
Do not use any type of additive for the
Electric Drive Unit fluid.
Avoid the use of transmission sealers,
since they may compromise the
efficiency of the Electric Drive Unit
seals.
WARNING Do not use chemicals to flush
the Electric Drive Unit, since this may
damage its components.
Frequency of oil changes
In normal car operating conditions, it
is not necessary to change the Electric
Drive Unit fluid.
If fluid leaks are noticed or irregular
operation of the Electric Drive Unit is
detected, have it checked immediately at
a Jeep Dealership.
WARNING Driving the car with an
insufficient oil level may cause serious
damage to the Electric Drive Unit.
WIPER BLADE REPLACEMENT
Windscreen
Switch off ignition.
Within 45 seconds after switching off
ignition, rise or low the right control stalk
to a stable position. The wiper blades
will be put vertically on the windscreen.
310
JJ000391
Lift the wiper arm until it stays in the
raised position, press button (1) fig. 310
to disengage the wiper blade and
remove.
Attach the new wiper blade to the wiper
arm and push until it engages.
Lower wiper arm carefully.
To return the wiper arms to their original
position, switch on the ignition and
operate the wiper lever.