Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 59 / 300

57
REAR FLOOR STORAGE COVER
102
JJ000485
The rear floor cover can be lifted and
removed. Use opening (1) fig. 102
to raise the rear floor cover and then
remove it.
DOUBLE LOAD FLOOR
(where provided)
103
JJ000486
The double load floor can be inserted in
the load compartment in two positions:
lower position above the rear floor
storage cover (1) fig. 103
upper position interlocked into back
panel trim (2) fig. 103
The floor can be inclined at 45
°
and
locked on the supports (3) fig. 103 for
facilitating the access to the load area
below the storage cover.
To remove, use opening to raise the rear
floor cover and lift it up.
If mounted in the upper position, the
space between the load floor and the
spare wheel well cover can be used as a
storage compartment.
In this position, if the rear seat
backrests are folded forwards, an almost
completely flat load bay is created.
In the upper position, the double load
floor is able to withstand an equally
distributed maximum load of 60 kg.
In the lower position, the double load
floor is able to withstand the maximum
permissible load.
LOADING INFORMATION
61)
Heavy objects in the load
compartment should be placed against
the seat backrests. Make sure that the
backrests are securely engaged. If
objects can be stacked, heavier objects
should be placed at the bottom.
Prevent sliding of loose objects by
securing them with straps attached to
the lashing eyes.
Do not allow the load to protrude
above the upper edge of the backrests.
Do not place any objects on the load
compartment cover or the instrument
panel, and do not cover the sensor on
top of the instrument panel.
The load must not obstruct the
operation of the pedals, parking brake
and gear selector, or hinder the freedom
of movement of the driver. Do not place
any unsecured objects in the interior.
Do not drive with an open load
compartment.
The payload is the difference between
the permitted gross vehicle weight (see
identification plate) and the EC kerb
weight To calculate the payload, enter
the data for your vehicle in the weights
table at the front of this manual.
The EC kerb weight includes weights for
the driver (68 kg), luggage (7 kg) and all
fluids (fuel tank 90% full).
Optional equipment and accessories
increase the kerb weight.
Driving with a roof load increases the
sensitivity of the vehicle to cross-winds
and has a detrimental effect on vehicle
handling due to the vehicle's higher
centre of gravity. Distribute the load
evenly and secure it properly with
retaining straps. Adjust the tyre pressure
and vehicle speed according to the load
conditions. Check and retighten the
straps frequently.
Do not drive faster than 120 km/h.
The permissible roof load is 50 kg. The
roof load is the combined weight of the
roof rack and the load.