Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 41 / 300

39
WIPER CONTROL STALK
11) 12) 13) 14)
NOTE After using an automatic car wash,
you may temporarily notice abnormal
noises and poorer wiping performance.
You do not need to replace the wiper
blades.
72
JJ000414
(1) Automatic wipers
(2) Intermittent wipers
WINDSCREEN WIPERS
To select the wiping speed: raise or lower
the stalk fig. 72 to the desired position.
2: Fast wiping (heavy rain)
1: Normal wiping (moderate rain)
Int: Intermittent wipers
Auto: Automatic wipers
0: Switching off
x1: Manual
NOTE In position 1 or 2, the wiping
frequency is automatically reduced
when the speed of the vehicle drops
below 5 km/h (3 mph). When the speed
is above 10 km/h (6 mph) again, the
wiping frequency returns to the original
frequency (fast or normal).
Single wipe
Press and release the control stalk or
briefly pull the control stalk towards you.
WINDSCREEN WASH
Pull the wiper control stalk towards
you and hold. A final wiping cycle is
performed when screenwashing ends.
NOTE With automatic air conditioning,
any action on the screenwash control
results in temporary closure of the
air intake to protect the passenger
compartment from any odour.
15)
FRONT INTERMITTENT WIPING
In Intermittent mode, the driver can
adjust the wiping frequency by turning
the ring (2) fig. 73 to one of the 5
available positions.
73
JJ000415
The first (upper) position corresponds
to the longest time interval between 2
wipes for light rain.
The last (lower) position corresponds
to the shortest time interval between 2
wipes for heavy rain.
A rotation of the ring from a higher
position to a lower position triggers a
confirmation wiping.
After the ignition has been switched off
for more than 1 minute with the wiper
control stalk in the INT, 1 or 2 position,
when the ignition is switched on again:
the system works as soon as the
vehicle exceeds 10 km/h (6 mph), if the
outside temperature is below +3
°
C.
the system works immediately, if the
outside temperature is above +3
°
C.
AUTOMATIC WINDSCREEN
WIPERS
In AUTO mode, the front wipers work
automatically and adapt to the intensity
of precipitation depending on the
sensitivity of the sensor selected.
The rainfall detection function uses a
rain/ sunshine sensor located at the top
centre of the windscreen, behind the rear
view mirror.
NOTE In certain weather conditions (e.g.
fog, frost, snow, projections on salty
roads), the driver may have to return to
manual wiping.