Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 18 / 300

KNOWING YOUR CAR
16
REINITIALISING THE REMOTE
CONTROL
Following replacement of the battery
or in the event of a fault, it may be
necessary to reinitialise the remote
control.
Radio remote control
insert the key in the ignition switch
and turn the key to position (2) fig. 8
8
JJ000429
immediately press the button for a
few seconds
turn back the ignition switch to the
position (0) fig. 8, and remove the key
from the ignition switch
The remote control is now fully
operational again.
If the fault persists after reinitialisation,
contact a Jeep Dealership without delay.
Electronic key
insert the mechanical key
(incorporated into the electronic key)
into the lock to open the vehicle
place the electronic key against the
back-up reader on the steering column
and hold it there until the ignition is
switched on fig. 9
9
JJ000513
with a manual gearbox, place the gear
lever in neutral then fully depress the
clutch pedal
with an Electric Drive Unit, while the
PRND command is in mode P, depress
the brake pedal
switch on the ignition by pressing the
STOP START ENGINE button
If the fault persists after reinitialisation,
contact a Jeep Dealership without delay.
CENTRAL LOCKING SYSTEM
Unlocks and locks doors, load
compartment and fuel filler flap.
A pull on an interior door handle opens
the respective door.
NOTE In the event of an accident in
which airbags or belt pretensioners are
deployed, the vehicle is automatically
unlocked.
Remote control operation
10
JJ000007
Unlocking
Press fig. 10 to unlock the doors
and switch on the interior and exterior
lighting (Welcome lighting).
The function "Welcome lighting" can
be activated/deactivated and adjusted
through the Uconnect™ 10.25"/10.25"
NAV system, fig. 11. See the "Guide-me-
home and welcome lighting" paragraph
in the "Exterior lighting" chapter.
11
JJ000716