Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 206 / 300

IN CASE OF EMERGENCY
204
281
JJ000658
remove the electrical connection cable
(2) fig. 281 and air hose (1) from the
stowage compartments on the underside
of the compressor
OFF ON
TI
R
E
CO
M
PRES
SO
R
TIRE SEALANT
282
JJ000702
join the sealant bottle to the
compressor (1) fig. 282 and rotate the
bottle 1/4 turn clockwise (2)
283
JJ000701
unscrew the valve cap from the
defective tyre and screw the filler hose to
the tyre valve (1) fig. 283
screw the other end of the filler hose
to the sealant bottle (2) fig. 283
connect the compressor plug to the
12V power outlet. To avoid discharging
the conventional battery, we recommend
running the engine
NOTE The vehicle's electric system
allows the connection of the compressor
to the 12 V power supply for long enough
to repair a tyre after a puncture.
turn the switch (3) fig. 283 to position
I (ON): all the sealant is pumped into the
tyre, then the tyre is being inflated
psi
bar
1
ba
r =
100
kPa
20 40
60
80
1 2
3 4 5 6
284
JJ000703
check the tyre pressure on the gauge
(1) fig. 284: if in 15 minutes the
indicator is not in the green area, the
tyre is too badly damaged. In this case
turn the switch (3) fig. 283 to position 0
(OFF) and seek the assistance of a Jeep
Dealership
If the indicator reaches the green area,
turn the switch (3) fig. 283 to position
0 (OFF), disconnect the electrical
connection cable from the 12V power
outlet
detach the tyre repair kit from the tyre
valve and reapply the valve cap
remove sealant bottle from compressor
by rotating it 90
°
anticlockwise and
remove any excess sealant using a cloth
Start driving in maximum 1 minute.
Maximum speed: 80 km/h (50 mph).
After driving approximately 15 minutes,
stop and check the tyre pressure.
For checking the tyre pressure:
screw one end of the compressor air
hose directly onto tyre valve and the