Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 145 / 300

143
anymore, a warning chime is given and a
message is displayed in the instrument
panel display. The message prompts the
driver to take back control of the vehicle.
On vehicles with Electric Drive Unit, the
system can brake the vehicle until a full
stop. Depending on variant, the system
can automatically accelerate the vehicle
after a full stop.
192)
STEERING-MOUNTED
CONTROLS
OK
SET_
SET+
ASSIST
LIMIT
185
JJ000610
(1) Activation of cruise control in
progress. Use the speed suggested by
the Road signs recognition
(2) Increase/Decrease the speed
setting (if cruise control activated).
Activation of cruise control in progress
(if cruise control deactivated). Display
and configuration of the inter-vehicle
distance setting
(3) Selection of cruise control alone or
Highway Driver Assist (depending on
version)/Deselection
(4) Switch on/pause cruise control
at the previously saved speed setting.
Confirmation of vehicle restart after
automatic stop
USE
Selecting the system
With the engine running, press
successively on (3) fig. 185 until
cruise control mode is displayed on the
instrument panel
after a few seconds, cruise control
mode is selected. The Driving aids
mini-view is displayed (grey) and cruise
control is ready to be activated
Switching on cruise control
The vehicle speed must be between 0
and 180 km/h (0 and 112 mph).
System activation is also subject to the
following conditions:
driver's door closed
driver's seat belt fastened
mode D selected on the Electric Drive
Unit
parking brake released
if the vehicle is stationary, brake pedal
depressed
The message "OK?" fig. 186 is displayed
if all the activation conditions are met.
186
JJ000611
press on (1): the current speed
becomes the speed setting (minimum
30 km/h (19 mph)) and cruise control is
immediately activated (green display)
Modifying the speed setting
To change the speed setting using the
vehicle’s current speed:
for steps of +/- 1 mph (1 km/h),
make successive short presses
upwards/downwards on (2) to
increase/decrease
for steps of +/- 5 mph (5 km/h), press
and hold upwards/downwards on (2) to
increase/ decrease
WARNING Prolonged pressing and
holding upwards/downwards on 3 causes
a rapid change in vehicle speed.
When the function is activated, it is
possible to change the speed setting
using the speed suggested by the Traffic
Sign Recognition function displayed on
the instrument panel:
When passing the sign:
Press OK to save the suggested