Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 36 / 300

KNOWING YOUR CAR
34
Three flashes
Press briefly upwards or downwards,
without going beyond the point of
resistance; the direction indicators will
flash 3 times.
Parking lamps
(where provided)
Vehicle side marking by lighting the
sidelamps on the traffic side only.
Within one minute after switching
off the ignition, operate the lighting
control stalk upwards or downwards,
depending on the side of the traffic (e.g.
when parking on the right, push the
lighting control stalk down to light up
on the left). This is confirmed by an
audible signal and the lighting of the
corresponding direction indicator lamp
on the instrument panel.
To switch off the parking lamps, return
the lighting control stalk to the central
position.
AUTOMATIC ILLUMINATION OF
LAMPS
With the lighting control stalk in the
“AUTO” position and if a low level of
exterior brightness is detected by the
rain/sunshine sensor, the sidelamps and
dipped beam headlamps are switched on
automatically, without any action on the
part of the driver. They may also come
on if rain is detected, at the same time
as automatic operation of the windscreen
wipers.
As soon as the brightness returns to a
sufficient level or after the windscreen
wipers are switched off, the lamps are
switched off automatically.
In the event of a malfunction of the rain/
sunshine sensor, the vehicle’s lamps
come on and this warning lamp
is displayed on the instrument panel,
accompanied by an audible signal
and/or the display of a message. Have it
checked by a Jeep Dealership.
9)
NOTE In fog or snow, the rain/sunshine
sensor may detect sufficient light. For
this reason, the lighting will not come on
automatically.
NOTE The inner surface of the
windscreen may become misted up
and affect the proper operation of the
rain/sunshine sensor. In humid and
cold weather, demist the windscreen
regularly.
Operating limits
The automatic lighting systems use a
detection camera, located at the top of
the windscreen.
The system may be disrupted or not work
correctly:
When visibility conditions are poor
(e.g. snowfall, heavy rain)
If the windscreen is dirty, misted-up
or masked (e.g. sticker) in front of the
camera
the vehicle is facing highly reflective
signs or safety barrier reflectors
The system is not able to detect:
Road users that do not have their own
lighting, such as pedestrians
Vehicles with hidden lighting (e.g.
travelling behind a safety barrier on the
motorway)
Vehicles at the top or bottom of
a steep slope, on winding roads, on
crossroads
10)
HEADLAMP BEAM HEIGHT
ADJUSTMENT
63
JJ000449
To avoid dazzling other road users, the
height of these headlamp beams must
be adjusted according to the load in the
vehicle.
Turn the gear (1) fig. 63:
0 (Initial setting): Driver only or
front passenger
1: 5 people
2: 5 load in the boot