Jeep AVENGER 2023, Owner'S Handbook Manual

Page: 37 / 300

35
3: Driver only + load in the boot
4, 5, 6: Not used
GUIDE-ME-HOME AND
WELCOME LIGHTING
Guide-me-home lighting
Automatic: with the ring of the lighting
control stalk in the "AUTO" position and
when the light is poor, the sidelamps
and dipped beam headlamps come
on automatically when the ignition
is switched off. The function can be
activated/deactivated and the guide-
me-home lighting duration adjusted
through the Uconnect™ 10.25"/10.25"
NAV
system (Settings>Vehicle>Vehicle
lighting).
Manual: with the ignition off, pull
the lighting control stalk toward you
("headlamp flash") to activate/ deactivate
the function. Manual guide-me-home
lighting goes off automatically after a
period of time.
Welcome lighting
(where provided)
When the vehicle is unlocked, if the
ambient light is low and the "Automatic
illumination of headlamps" function is
activated, this system automatically
turns on certain exterior lamps as well
as certain lamps in the passenger
compartment. The function can be
activated/deactivated and the welcome
lighting duration adjusted through the
Uconnect™ 10.25"/10.25" NAV system,
fig. 64.
64
JJ000716
AUTOMATIC HEADLAMP
DIPPING
With the ring of the lighting control stalk
in the "AUTO" position and the function
activated on the touch screen, this
system automatically switches between
dipped and main beam headlamps when
a vehicle approaches in the opposite
direction, using a camera located at the
top of the windscreen.
46) 47)
NOTE The system becomes operational
when the vehicle exceeds 25 km/h (16
mph). When the speed falls below 15
km/h (9 mph), the function is no longer
operational.
The function can be
activated/deactivated through the
Uconnect™ 10.25"/10.25" NAV system
(Settings>Vehicle>Vehicle lighting),
fig. 65.
65
JJ000719
Operation
If the ambient light level is very low
and traffic conditions permit, the main
beam headlamps come on automatically.
The lamps
and light up on the
instrument panel.
If the ambient light level is sufficient
and/or the traffic conditions do not allow
the main beam headlamps to be lit, the
dipped beam headlamps remain lit.
and
light up on the instrument panel.
The function is deactivated if the
foglamps are switched on or if the
system detects poor visibility conditions
(e.g. fog, heavy rain, snowfall).
When the foglamps are switched off or
when the visibility conditions become
favourable again, the function is
automatically reactivated.
The lamp
goes out when the
function is deactivated.