Janssen F Series, Operating Instructions Manual

Page: 31 / 315

29
3.6.1.12 Gear unit housing
The gear unit housing contains the
gear wheels, the drive motors and the
mechanics of the knife adjustment.
The gear unit housing must only be
opened by trained specialist person-
nel.
( Section "9.13 Knife setting for the
cookie thickness", p. 76
and
section "11.6 Gear unit", p. 142
and
section "11.6.1 Lubrication of the gear
unit", p. 143)
3.6.1.13 Switch housing
The main switch of the machine and
the supply cable are located on the
front of the switch housing. The
electrical controller of the machine is
located in the switch housing. The
housing must only be opened by
instructed specialist personnel
(electricians).
(
Section "11.8 Controller", p. 145
)
3.6.1.14 Operating terminal
Janssen cookie formers are operated
via the operating terminal. The
terminal can be swivelled about its
vertical axis and locked in place with a
clamping sleeve.
The operating terminal can be
equipped either with analogue buttons
and potentiometers (Compact) or a
touch display (Performance) (
section 10
).
Both versions have a button bar on
the side with the main functions:
3.6.1.15 Power cord holder
The supply cable and the power plug
are properly connected by the
manufacturer (
section "2.6 External
interfaces", p. 13
). The cable can be
wrapped around the cable holder or
handle located on the gear unit side
when the machine is taken out of
operation.
3.6.2. Controller design
The Janssen cookie formers F250,
F450 and F600 can be operated with a
programmable "Performance"
controller with touch display or
manually with a non-programmable
"Compact" controller. The "Compact"
controller is considerably more
limited in its range of functions than
the "Performance" controller, but it is
very easy to operate.
EMERGENCY
STOP
STOP
ENABLE
(reset / release)
START