ITT Industries PumpSmart PS200, Configuration & Operation Manual

Page: 17 / 159

PS200 Configuration & Operation Guide
SINGLE PUMP PROCESS
Page 15
3
Select Operating Mode and Units
In this section, the operating mode is selected and the primary process
transmitter is configured.
OPERATING MODE
There are four modes for operating the PumpSmart PS200:
Pressure, Flow, Level, or Temperature/Other. This selection
pre-selects the defaults for units and PI control settings [See
TUNING].
x Pressure – PumpSmart will work to maintain a pressure
setpoint based on a pressure transmitter signal.
x Flow – PumpSmart will work to maintain a flow setpoint
based on a flowmeter signal.
x Level – used to maintain a defined tank level based on a
level transmitter feedback, although a pressure
transmitter at the pump suction can also be used.
PumpSmart can control the level in either a suction or
discharge tank.
x Temperature/OTHER – used to maintain defined
temperature of a process stream based on a temperature
transmitter signal. Also use this selection if a 4-20 ma
signal from a different type of transmitter is used.
11.03 MODE SELECT
KEY SEQUENCE
[From parameter group: 14.02 MINIMUM
SPEED]]
OR
Scroll to parameter group
11 START-UP DATA
OR
Scroll to parameter 11.03
“OPERATING MODE”
ENTER
Press to enter the
parameter setting mode
OR
Scroll to selection
Example – Pressure
Select the control mode
for your application. If
the control mode is
PRESSURE, skip to the
next step (Process
Variable selection).
Options:
Pressure
Flow
Level
Temperature/Other
ENTER
Press to complete the
entry
ACT PAR FUNC DRIVE
ENTER
1 L
Æ
0 P S I G 0
1 1 S T A R T - U P D A T A
0 3 M O D E S E L E C T
PRESSURE
Operating Mode
Select
Process
Transmitter
Configuration
Process Variable
Selection
3
1
2
4
!