Chapter 4: Commands for CLI configuration
Example:
To enable the function (
network-clock synchronization ssm
)
for
GigabitEthernet X/X.
Switch# configure terminal
Switch (config)#
interface GigabitEthernet X/X
Switch (config-if) #
no network-clock synchronization ssm
ping ip
Command:
ping ip <ipv4_addr> size <size: 2-1452>
ping
The ping command allows you to test connectivity to a network host from the
appliance
ip
ip
<ipv4_addr>
IP address
size
size
<size: 2-1452>
Default is 56 (excluding MAC, IP and ICMP headers)
Default:
N/A
Usage Guide:
To run Ping function
for specific interface
Example:
To run Ping function (IP address: 10.10.10.10 with size 88 bytes)
for
GigabitEthernet X/X.
Switch# configure terminal
Switch (config)#
interface GigabitEthernet X/X
Switch (config-if) #
ping ip 10.10.10.10 size 88
poe mode
Command:
poe mode { standard | plus }
poe
Power Over Ethernet.
mode
PoE mode.
plus
Set mode to PoE+ (Maximum power 30.0 W)
standard
Set mode to PoE (Maximum power 15.4 W)
Default:
N/A
Usage Guide:
To configure 802.3at/af mode
for specific interface
Example:
To configure 802.3at mode
for
GigabitEthernet X/X.
Switch# configure terminal
Switch (config)#
interface GigabitEthernet X/X
Switch (config-if) #
poe mode plus
NS3500-24T-4C Managed Switch Command Guide
87
