Chapter 4: Commands for CLI configuration
Switch# configure terminal
Switch (config)#
evc ece 1 direction both evc 2 frame-type ipv4
inner-tag add dei 1 pcp 4 preserve type s-custom-tag vid 5
interface GigabitEthernet 1/3 outer-tag add dei 0 mode enable
pcp 2 vid 7 match dei any pcp any type c-tagged vid 6 policer
8 policy 9 pop 2
evc ece update
Command:
evc ece update <EceId : 1-4096> direction {both | nni-to-uni |
uni-to-nni} evc {<EvcId : 1-4096> | none} frame-type {any |
ipv4 | ipv6} inner-tag { add {dei <AddDei : 0-1> | pcp
<AddPcp : 0-7> | preserve | type [c-tag | none | s-custom-tag |
s-tag] | vid <AddVid : vlan_id>}, match {dei [<MatchDei : 0-1> |
any]| pcp [<MatchPcp : pcp> | any] | type [any | c-tagged | s-
tagged | tagged | untagged] | vid [<Vid : 0-4095> | any]} }
interface [* | 10GigabitEthernet | GigabitEthernet] <PORT_ID>
next [<EceId : 1-4096> | last] outer-tag { add {dei <AddDei : 0-
1> | pcp <AddPcp : 0-7> | preserve | type [c-tag | none | s-
custom-tag | s-tag] | vid <AddVid : vlan_id>}, match {dei
[<MatchDei : 0-1> | any]| pcp [<MatchPcp : pcp> | any] | mode
[disable | enable] | vid [<Vid : 0-4095> | any] } policer
{<PolicerId : 1-2048> | discard | evc | none} policy <PolicyNo :
0-255> pop <Pop : 0-2>
<EceId : 1-4096>
ECE identifier
direction
Setup ECE direction
both
Bidirectional traffic flow
nni-to-uni
NNI-to-UNI traffic flow
uni-to-nni
UNI-to-NNI traffic flow
evc
EVC mapping
<EvcId : 1-4096>
EVC identifier
none
Map to no EVC ID
frame-type
Setup matched frame type
any
Match any frame type
ipv4
Match IPv4 frames
ipv6
Match IPv6 frames
inner-tag
Setup inner tag options
add
Setup inner tag add properties
.
dei
Setup added tag DEI
<AddDei : 0-1>
Added tag DEI
pcp
Setup added tag PCP
<AddPcp : 0-7>
Added tag PCP
preserve
Setup tag PCP/DEI preservation
type
Setup added tag type
54
NS3500-24T-4C Managed Switch Command Guide
