4
Several work-in-progress panels will appear, followed by a
message stating that the IBM EtherJet ISA adapter driver has
been installed. Select OK.
5
Select Configure in the next window.
6
On the Configure panel make sure LAN adapter and
protocols button is selected. Select Configure.
7
The panel named LAPS CONFIGURATION appears next (for
both LAPS and MPTS). In the Network Adapters list box,
select either the IBM EtherJet ISA Adapter or the IBM EtherJet
10BASE-T ISA Adapter and select Add.
The adapter name will show up in the Current Configuration list
box at the bottom of the panel.
Note: You can edit network parameters for this adapter by
selecting it from the Current Configuration list box and then
selecting Edit.
8
In the Protocols list box, select the protocols you need for the
adapter and then select Add after each one you have selected.
If you are not certain what protocols you need, then select both
IEEE 802.2 and NetBIOS.
Note: You can edit network parameters for each of the
protocol drivers by selecting them in the Current Configuration
list box and then selecting Edit.
9
If you are installing more than one card, repeat the previous
two steps for each card you want to configure.
10
Select OK from the LAPS Configuration panel when you have
finished your selections for your cards.
11
Exit the program. You will see update windows for changes to
the CONFIG.SYS, STARTUP.CMD, and the PROTOCOL.INI
files. Select Exit or OK in each window.
12
Shut down and restart your computer for all changes to take
effect. Messages will tell you that installation is completing
6-18
EtherJet ISA Adapters Installation and User Guide
Title: ANW0CNTL CreationDate: 09/29/95 12:51:21
All manuals and user guides at all-guides.com
