IBM eserver 630 6C4, Service Manual

Page: 229 / 573

Table 6. Service Processor Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
406B 0130 Memory extender 0 on processor card 2 Processor card,
Location: U0.1-P1-C2
406B 0131 Memory extender 2 on processor card 2 Processor card,
Location: U0.1-P1-C2
406B 0A03 Reboot message on VPD channel 3
processor card 1. Reboot is necessary
for run-time array gard to take effect.
Reboot the system in slow mode. Run
diagnostics, then go to
″
MAP 0235:
System Array Self-Repair Problem
Resolution
″
in the RS/6000
Eserver
pSeries Diagnostic Information for
Multiple Bus Systems
.
406B 0A04 Reboot message on VPD channel 4
processor card 2. Reboot is necessary
for run-time array gard to take effect.
Reboot the system in slow mode. Run
diagnostics, then go to
″
MAP 0235:
System Array Self-Repair Problem
Resolution
″
in the RS/6000
Eserver
pSeries Diagnostic Information for
Multiple Bus Systems
.
406B 0B00 I/O slot 0, I/O port 0 (problem outside
the CEC drawer)
Go to “MAP 1540: Minimum
Configuration” on page 101.
406B 0B01 I/O slot 0, I/O port 1 (problem outside
the CEC drawer)
Go to “MAP 1540: Minimum
Configuration” on page 101.
406B 0B02 I/O slot 0, I/O port 2 (problem outside
the CEC drawer)
Go to “MAP 1540: Minimum
Configuration” on page 101.
406B 0B03 I/O slot 0, I/O port 3 (problem outside
the CEC drawer)
Go to “MAP 1540: Minimum
Configuration” on page 101.
406B 0BF0 I/O slot 0, I/O port x (problem outside
the CEC drawer)
Go to “MAP 1540: Minimum
Configuration” on page 101.
406B 0CA5 Invalid processor configuration Check that the processor cards are
properly installed and configured.
406B 0CA6 No usable memory left in the system.
The system must be rebooted.
Go to “MAP 1240: Memory Problem
Resolution” on page 73.
406B 0CA9 Incorrect/incompatible memory DIMMs
are installed.
Check that the memory DIMMs are
properly configured, and are the right
type for the system.
406B 0CAA System memory exceeds the limit for
this system type and model.
Remove the memory DIMMs until the
memory does not exceed the limit for
this system type and model.
406B 0EA0 MOPS service processor code error.
1. Check for system firmware updates.
2. Call service support.
406B 0EA1 Operating system code on main
processor
1. Check for operating system code
updates.
2. Call service support.
Chapter 5. Error Code to FRU Index
209