IBM eserver 630 6C4, Service Manual

Page: 277 / 573

Table 6. Service Processor Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
4B2F 26FA 2-way processor card fault Replace the processor card specified by
the location code.
4B2F 26FB 2-way processor card fault Replace the processor card specified by
the location code.
4B2F 26FD 1-way processor card fault Replace the processor card specified by
the location code.
4B2F 26FE 2-way processor card fault Replace the processor card specified by
the location code.
4B2F 26FF 1-way processor card fault Replace the processor card specified by
the location code.
Memory DIMM Present Detect Bits (PD-Bits)
The following table expands on the Memory Error Notes found on page 175, where yy
is the PD value in the table below and xxx are the last three digits of the error code.
Use these values to identify the type of memory that generated the error.
If you replace FRUs or perform an action, and the problem is still not corrected, go to
“MAP 1540: Minimum Configuration” on page 101 unless otherwise indicated in the
tables.
Table 7. Memory DIMM PD bits
PD value Size Clock Cycle (nsecs) Parity/ ECC
28 512 MB 10 ECC
2A 512 MB 8 ECC
5A 32 MB 8 ECC
68 256 MB 10 ECC
6A 256 MB 8 ECC
Note: Memory DIMMs must be installed in quads.
Error Log Utility Procedure
When the System Management Services menu appears, check the error log for any
errors. Use the location code obtained from the SMS error log utiltity to identify the
component the error is reported against. To obtain the location code from the error log
utility do the following:
1. Choose View Error Log from the SMS main menu.
2. If an error is logged, check the time stamp.
3. If the error was logged during the current boot attempt, record it.
Chapter 5. Error Code to FRU Index
257