IBM eserver 630 6C4, Service Manual

Page: 517 / 573

e. Remove the rack-mounting template from the front of the rack. You should now
have placed on the front of your rack 2 nut clips and 4 self-adhesive dots.
f. Continue to step 5.
The following illustration shows a 1 EIA section and a 4 EIA section. Depending on
the rack manufacture the EIA sections may be separated by either color or by a
line. Note the holes along the rail are not evenly spaced. If your rack has no color
or line separation between EIAs, then assume that each EIA section begins where
the hole spacing is closest together.
2 Adhesive Dot Placement 4 EIA Hole Spacing
3 Nut Clip
4. If you do not have a rack mounting template do the following:
a. Determine where in the rack to place the system, make note of the EIA
location number.
Note: An EIA section on your rack consist of a grouping of three holes. Each
EIA section may be separated by either a color or a line. The system
you are about to install measures 4 EIA high.
b. Facing the front of the rack and working from the right side, place a supplied
self-adhesive dot next to the top hole of the bottom EIA.
Note: The self-adhesive dots are used to aid in identifying locations on the
rack. If you no longer have any of the dots use some other form of
marking tool to aid you in identifying hole locations. (for example:
marker, pencil)
Appendix D. Setting Up the System
497