IBM eserver 630 6C4, Service Manual

Page: 127 / 573

Step 1540-7
No failure was detected with this configuration.
1. Turn off the power and remove the power cords.
2. Reinstall processor card #2.
3. Plug in the power cords and wait for the OK prompt to display on the operator panel
display.
4. Turn on the power.
Does the system stop with code E1F2, E1F3, STBY or 20EE000B, 4BA00830
displayed on the operator panel?
NO One of the FRUs remaining in the system unit is defective.
Exchange the FRUs that have not been exchanged, in the following order:
1. Memory DIMMs, if present on processor card #2, exchange one at a time
with new or previously removed memory DIMMs.
2. Processor card #2 (last one installed)
3. CEC backplane (see notes on page 57)
Repeat this step until the defective FRU is identified or all the FRUs have been
exchanged.
If the symptom did not change and all the FRUs have been exchanged, call
your service support person for assistance.
If the symptom changed, check for loose cards and obvious problems. If you
do not find a problem, go to the “Quick Entry MAP” on page 58 and follow the
instructions for the new symptom.
YES Go to “Step 1540-8” on page 108.
Chapter 3. Maintenance Analysis Procedures (MAPs)
107