IBM eserver 630 6C4, Service Manual

Page: 532 / 573

Connect the LAN Cable (If Applicable)
The LAN cable is recommended because an active partition reports errors to the HMC’s
Service Focal Point application through the LAN network. The HMC must be attached
to the system’s LAN, and a partition should have a LAN adapter assigned as a
resource.
Connect the LAN to the adapters assigned to the partition and to the LAN connection
on the HMC system hardware.
Plug in the HMC Power Cable
1. Plug in the power cable as shown in the following illustration.
2. Plug in the power cables for the monitor, HMC, and modem into electrical outlets.
Configure the Network
To configure the network, do the following:
v
Log in to the (HMC) using the user ID
hscroot
and password
abc123
.
Note: User IDs and passwords are case-sensitive. Enter the user ID and password
exactly as shown.
v
Select the System Configuration Application in the Navigation area.
v
Select Customize Network Settings in the Contents area.
v
Type the appropriate network information in the IP Address, Name Services, and
Routing tabs on the Network Configuration window.
v
Select OK.
For more information on configuring the network, refer to the IBM Hardware
Management Console, order number SA38-0590.
Configure Inventory Scout Services
Inventory Scout Services is an AIX tool that surveys managed systems for hardware
and software information.
512 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide