IBM eserver 630 6C4, Service Manual

Page: 200 / 573

Table 5. Firmware Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
29B0 0004 Mouse not present/detected
1. Mouse
2. Replace CEC backplane
Location: U0.1-P1
2B20 0011 Processor is manually disabled Use the service processor menus to
re-enable the processor and reboot the
system
2B20 0022 Processor is deconfigured by the
system
The processor has previously failed
BIST or POST. Replace the processor
card indicated by the location code
associated with the error code in the
error log.
2B20 0031 Processor is failing POST. Replace the processor card indicated by
the location code associated with the
error code in the error log.
2B20 0042 Unknown processor card Remove the unknown/unsupported
processor card.
2B20 8880 Unrecoverable internal hardware error Replace the FRU indicated by the error
log entry.
2B20 8881 Software error Call service support.
2B20 8882 Software error Call service support.
2B20 8883 Software error Call service support.
2B20 8884 Unrecoverable processor subsystem
error
Replace the FRU indicated by the error
log entry. If the system has been
rebooted, run diagnostics and look for
an AIX error log entry in which the
description says cache or cache
controller error. Replace the FRUs listed
in this entry.
2B20 8885 Unrecoverable internal hardware error Run diagnostics. Look for an AIX error
log entry in which the description says
I/O bus time out, access, or other error
or I/O bridge/device internal error.
Replace the FRUs listed in this entry.
2B20 8888 Operating system termination request
received
Informational message.
180 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide