IBM eserver 630 6C4, Service Manual

Page: 245 / 573

Table 6. Service Processor Error Codes. (continued)
Error Code Description Action/
Possible Failing FRU
406F 0EB9 Attention line 8 stuck fault Go to “MAP 1540: Minimum
Configuration” on page 101.
406F 0EBA Attention line 9 stuck fault Go to “MAP 1540: Minimum
Configuration” on page 101.
406F 0EBB Attention line 10 stuck fault Go to “MAP 1540: Minimum
Configuration” on page 101.
406F 0EBC Attention line 11 stuck fault Go to “MAP 1540: Minimum
Configuration” on page 101.
406F 0EE1 Service processor firmware: invalid
MRU to FRU mapping
1. Check for system firmware updates.
2. Call service support.
406F 0EE2 Service processor firmware fault
1. Check for system firmware updates.
2. Call service support.
406F 0EE5 Firmware error, no callout available
1. Check for system firmware updates.
2. Call service support.
4503 26F6 Description: 1-way processor card fault
Action: This error code indicates that the processor repeat gard function has
deconfigured a processor. Do the following:
1. Go to the processor configuration/deconfiguration menu, located under the
system information menu in the service processor menus.
Look at the status of the processors. If any of the processors have a status of
″
manually deconfigured
″
, reconfigure the processor(s) and boot the system to
the SMS menus. Power down the system using the white power button and
look again at the status of the processors. If all of the processors are still
configured in the processor configuration/deconfiguration menu, the problem
has been resolved.
If any of the processors have a status of
″
deconfigured by the system
″
, either
before or after the boot to the SMS menus, go to step 2.
2. Replace the processor card (on which the deconfigured processor resides)
specified by the location code.
Chapter 5. Error Code to FRU Index
225