IBM eserver 630 6C4, Service Manual

Page: 282 / 573

Table 9. Common Firmware Error Codes (continued)
Error Code Description Action/
Possible Failing FRU
B1xx 4634 SPCN loop fault
1. Check SPCN cabling
2. Go to “MAP 1540: Minimum
Configuration” on page 101.
B1xx 4644 Processor VPD fault Ignore all location codes.
Go to “MAP 1540: Minimum
Configuration” on page 101 and run
CEC minimum configuration.
B1xx 4645 Non-processor VPD fault Ignore all location codes.
Go to “MAP 1540: Minimum
Configuration” on page 101 and run
CEC minimum configuration.
B1xx 4646 General VPD fault Ignore all location codes.
Go to “MAP 1540: Minimum
Configuration” on page 101 and run
CEC minimum configuration.
B1xx 4647 The machine type and model reported
by the CEC hardware do not match the
machine type and model stored in the
VPD module on the operator panel.
Replace the operator panel, location:
U0.1-L1. Do not swap the VPD module
from the old operator panel onto the
new operator panel; leave the new,
unprogrammed VPD module on the new
operator panel. Call service support for
instructions on reprogramming the
machine type, model, and system serial
number in the VPD module.
B1xx 4648 CEC backplane VPD failure Ignore all location codes.
Go to “MAP 1540: Minimum
Configuration” on page 101 and run
CEC minimum configuration.
B1xx 4649 Power supply VPD failure CEC power supply
Location: U0.1-V1, U0.1-V2
B1xx 4650 A system processor failure has been
detected by the service processor. All
system processors have been reset in
an attempt to recover operations.
Information only. If the problem persists,
check the error logs for other fault
indications.
If no other fault indications are found,
go to “MAP 1540: Minimum
Configuration” on page 101.
B1xx 4651 CPU VPD fault Processor card
Location: U0.1-P1-C1, U0.1-P1-C2
B1xx 4660 Memory subsystem failure Go to “MAP 1540: Minimum
Configuration” on page 101.
B1xx 4661 Memory card VPD failure Go to “MAP 1540: Minimum
Configuration” on page 101.
B1xx 4662 Memory DIMM VPD failure Go to “MAP 1540: Minimum
Configuration” on page 101.
262 Eserver
pSeries 630 Models 6C4 and 6E4 Service Guide