IBM E10, Service Manual, Page: 242 / 279

Local User Function User Interface Local async console
Text based menus with NLS
Operator Panel messages
Power and Miscellaneous Power On/Off
Configurable Reboot Policy
Status and Data Access VPD
Error data (SP)
Error data (system)
Environmental data
SP Setup Utilities Passwords
Phone numbers
Language (NLS) selection
Call In/Call Out enable/disable
Flash (Gold/Recovery block) Update
Flash (Composite block) Update
System Name
Modem Configuration
Remote User Functions Call Out (Call Home) Reporting Boot failure
OS Termination
Surveillance failure
Critical EPOW reporting
Checkstop
Machine check
Identify system by name Call In
Power-on via ring-indicate
Password/security check
Console mirroring/Quick disconnect
Application Interface Functions Monitor/Sense Thermal/Voltage/fan speed
SP Flash Update(Recovery and
Composite)
System Power-On Methods
v
Power on switch, see “Starting the System Unit” on page 232.
v
SP Menu power-on request
You can request a power-on via the SP menus from either a local or remote terminal.
If a remote terminal is to be used, the modem must be connected to serial port 1, and the operating
system set up to enable a TTY login session on that port.
Refer to “Seamless Transfer of a Modem Session” on page 232 for information on transferring modem
sessions from SP to the operating system.
v
Unattended start mode - refer to Enable/Disable Unattended Start Mode on page 218.
The SP can be enabled to recover from the loss of AC power (see Enable/Disable Unattended
Power-On Mode in the SYSTEM POWER CONTROL MENU). When AC power is restored, the system
returns to the then current power state at the time AC loss occurred. For example, if the system was
Service Processor Connection
226
VOLUME 3, ESS Service Guide