IBM E10, Service Manual, Page: 120 / 279

Table 10. SP Checkpoints. (continued)
Checkpoint Description Action/ Possible Failing FRU
E241 Reset PCI bus I/O Planar, see 1 on page 100
E242 Initialize ISA DMA channel I/O Planar, see 1 on page 100
E243 Setup grackle configuration registers I/O Planar, see 1 on page 100
E244 Enable system speaker and send a beep! I/O Planar, see 1 on page 100
E246 System firmware corrupted, take recover
path I/O Planar, see 1 on page 100
E247 Capture DIMM SPDs into NVRAM I/O Planar, see 1 on page 100
E249 Enter recover paths main code I/O Planar, see 1 on page 100
E24C L2 cache array test fails, system hangs I/O Planar, see 1 on page 100
E24D L2 cache array test fails, system hangs I/O Planar, see 1 on page 100
E297 Start firmware softload path execution See 1 on page 100
E298 Start firmware recovery path execution See 1 on page 100
E299 Start C code execution See 1 on page 100
E600 SSA PCI adapter open firmware has run
successfully SSA card, identify the adapter by using
″
MAP
4540: Cluster Minimum Configuration
″
in
chapter 3 of the Enterprise Storage Server
Service Guide, Volume 1 to isolate the failing
SSA card
E601 SSA PCI adapter BIST has been started but
failed to complete after four seconds See Action/Possible Failing FRU with
Checkpoint E600
E602 SSA PCI adapter open firmware has started See Action/Possible Failing FRU with
Checkpoint E600
E603 SSA PCI adapter BIST has completed with
an error See Action/Possible Failing FRU with
Checkpoint E600
E604 SSA PCI adapter BIST and following POSTs
have completed successfully See Action/Possible Failing FRU with
Checkpoint E600
E605 SSA PCI adapter BIST has completed
successfully, the following POSTs have failed See Action/Possible Failing FRU with
Checkpoint E600
E60E SSA PCI adapter open firmware about to
exit (no stack corruption) See Action/Possible Failing FRU with
Checkpoint E600
E60F SSA PCI adapter open firmware has run
unsuccessfully See Action/Possible Failing FRU with
Checkpoint E600
E6FF SSA PCI adapter open firmware about to
exit (with stack corruption) See Action/Possible Failing FRU with
Checkpoint E600
F0FF Service processor firmware fail See “Firmware/POST Error Codes” on
page 73 for 4BA10004
OK SP Ready Waiting for Power-On None, Normal operation
READY SP Cluster Bay may be powered off if
CD-ROM tray does not open when the eject
button is pressed None, Normal operation
STBY SP Ready, system was shutdown by the
operating system and is still powered on This condition can be requested by a
privileged system user with no faults. See SP
error log for possible operating system fault
indications.
Codes
104
VOLUME 3, ESS Service Guide