IBM E10, Service Manual, Page: 161 / 279

ESC Description of ESC
285A CPI IOA private bus error during configuration
285B CPI IOM private bus error during configuration
2870 IOM PLX Master abort
2871 IOM PLX Target abort
2872 IOM PLX Received Target abort
2873 IOM PA check error on cluster bay 1
2874 IOM PA check error on cluster bay 2
287F PCI target abort detected by IC
2880 IOA invalid local bus byte enables
2881 IOA internal error
2882 CPI bay power sense failure
2883 IOM detected IOA/IOM interface error
2884 IOM internal error
2885 IOM SDRAM error
2886 IOA check summary without supporting check
2887 System bus error counter overflowed
2888 Address error on system PCI bus
2889 BLRC from dual port
288A Data error on system PCI bus
288B IOM PA check error
288C Master abort error on system PCI bus
288D IOM PA Check Registers Disagree
288E Target abort error on system PCI bus
288F CPI read hang failure
2890 NVS-VY address error on system PCI bus
2891 NVS-XC address error on system PCI bus
2892 IOA address error on system PCI bus
2894 IOA/IOM private bus error counter overflowed
2895 NVS-VY System Bus Error Counter overflowed
2896 NVS-XC System Bus Error Counter overflowed
2897 Single CPI path in post sink source
2898 Both CPI paths in post sink source
289A CPI caused CPI pre-post sink source error
289B CPI error without supporting check
289C CPI fault not Isolated
289D CPI remote failure not isolated
289E CPI IOA flash error detected
289F CPI IOM flash error detected
28A0 Forced CPI shared error
28A1 CPI failed to enter source/sink mode for forced error
28A2 Reset Failure, Fence Host Bay 1, Host Bay 2 and Cluster Bay 2
2105 Exception Symptom Codes
Error Messages, Diagnostic Codes, and Service Reports, CHAPTER 9
145