IAI ERC3, Instruction Manual

Page: 59 / 188

Chapter 3 Operation
3.2 Initial Setting
51
3.2 Initial Setting
The settings are to be conducted with RC PC Software
(Note)
or Touch Panel Teaching
(Note)
. Also
the setting for the operation mode is to be conducted with Gateway Parameter Setting Tool (Ver.
1.2.0.0 or later).
(Note) Connectable teaching tools should be checked in 1.1.2 Teaching Tool.
Also, for the applicable version of each teaching tool, refer to the instruction manual of
each. [Refer to 1.1.3 Instruction Manuals Related to This Product, Which are Contained
in the Instruction Manual (DVD)]
Shown below is the process for the setup. Follow the instruction to conduct the setting properly.
[Preparation] Install RC PC Software and Gateway Parameter Setting Tool. For Gateway
Parameter Setting Tool, install the file stored in the CD-ROM for PC software, or
download from our homepage.
[Refer to the instruction manual of the PC software for the details of the PC
software.]
Make sure the power, system I/O connector wires and operation mode setting switch are in
MANU condition when having the setting done.
[Step 1] Connect the PC to SIO connector on ERC3 Gateway Unit with using the cable enclosed
in RC PC software, and start up Gateway Parameter Setting Tool.
[Step 2] Controller Select window shows up. Select ERC3 GW and press OK.
[Step 3] The main window opens.
ME0302-4A