IAI ERC3, Instruction Manual

Page: 143 / 188

Chapter 3 Operation
3.7
About Gateway Parameter Setting
Tool
135
3.7 About Gateway Parameter Setting Tool
This tool is necessary for the initial setting process such as ERC3 operation mode select.
Shown below is how to use the tool.
3.7.1 Startup of Tool
1) Boot the Gateway Parameter Setting Tool after the power to ERC3 is turned ON, and the
window shown below appears. Select “ERC3 GW” if ERC3 is connected and click OK.
2) The main window opens. The main window opens even when ERC3 could not be detected.
Click on the “Read” button in this window and the parameters start to be read from ERC3.
Parameter transfer starts if the “Write” button is clicked. However, note that the transfer
cannot be made if there is a blank like Address and Baud Rate in the figure below.
Main Window (Initial condition)
ME0302-4A