70
Note:
• HDD information will not be updated while the
"Maintenance" page is being displayed.
• The recovery progress information is displayed
next to the HDD operation mode display during
mirroring recovery.
• If this product is under heavy load, images may
not be recorded for several seconds at layback
during mirroring recovery.
[Operation mode of HDD]
Operation mode of HDD will be displayed.
Refer to "About the HDD operational mode"(
☞
page
79 ) for further information.
[Capacity]
Displays the capacities of the hard disk drives.
[Operation]
Displays the operating time of the hard disk drives.
[Status]
Displays the statuses of the hard disk drives.
Normal: Hard disk drives that are operating
normally. The number indicates the order of
use.
Playback-only: Hard disk drives for playback use
only (Recording is unavailable.)
Removed: Hard disk drives that are excluded
from operation due to fault
Error: Hard disk drives that have become faulty
during the format process
Blank: No HDD connected
Added: HDD cannot be used until it is formatted
[Recorded time range]
Displays the time range of the images recorded on
the hard disk drives.
Note:
• Although the range of date and time are displayed
for the recovery target HDD even during mirroring
recovery, the content will not be the same as the
recovery source HDD until the recovery is
completed.
[Overwrite cycle]
Calculates and indicates the overwriting cycle of the
hard disk drives, based on the past recording
performance (the date & time of the oldest recorded
data, the current date & time and the capacity of the
hard disk drive).
Note:
• While overwriting recording is being performed,
the overwriting cycle will be calculated based on
the date & time of the oldest recorded data and
that of the newest recorded data.
• The more often the recording was performed in
the past, the more accurate the calculation of
overwriting cycle will be.
• When the recording conditions are changed or
when data is automatically deleted, the
overwriting cycle will not be indicated accurately.
[HDD remaining capacity]
Displays remaining capacity of HDD. Also, the timing
to notice when the capacity becomes low can be set.
Click [View] button to display HDD remaining
capacity.
Example above shows the screen for single mode.
Confirm the hard disk drive information [HDD information]
Capacity of the hard disk drive and the running time of this product, time range of the recorded images, etc. will
be displayed.
[Setup via recorder's main monitor]
