37
Set up VMD alarm for individual cameras [VMD alarm (Advanced individual camera
setup)]
Select the motion detection area and detection sensitivity for each camera and transmit the information to the
cameras to change the camera settings.
Clicking the "Advanced individual camera setup" [Setup >] button for "VMD alarm" on the [Camera setup] tab
will display the setup page.
Note:
• This menu collects setting information from the selected camera and applies it on the setting screen.
• Only the fisheye network camera can set the "Fisheye" mode.
[Camera selection]
Select the camera for which you want to set the VMD
alarm.
[Select a preset position]
If the selected camera is a camera with preset
function, the preset position is selected.
[Model] [Error information]
☞
[Setup VMD area]
Click the top left corner and bottom right corner of
the square on the screen, set the specified position
as area 1, and display the area box. Area will be set in
numerical order starting form area number 1. When
the [Delete] button is clicked, the designated area will
be deleted.
Note:
• Depending on the position of the area box, it is
sometimes corrected slightly after the transfer
settings.
• If the area box is too small, the area number will
not be displayed correctly.
[Status]
When the motion detection area is set to Off, the
status of the area will be switched to "Off".
[Detection sensitivity]
Set the sensitivity when moving within the area to be
detected.
1 (low) ~ 15 (high)
[Transmission] button
Transmit the setting of the "VMD alarm" to the
camera. Once transmission is completed and the
setting has been applied to the camera, "OK" will be
displayed in the "Results" field. When the Error
information is not displayed as "-", it cannot be
transferred to the camera.
[Back] button
Click the button after completing the settings. The
screen returns to the [Camera setup] tab.
[Setup via recorder's main monitor]
