166
Event function
The recorder will take an event action when any of the following events occur.
Terminal alarm:
An event when an alarm input signal is supplied from an external device such as a
door sensor to the alarm input terminal on the rear of the recorder.
Camera site alarm:
An event when an alarm (camera terminal alarm, etc.) is detected by a camera.
Command alarm:
An alarm when receiving an alarm from a PC, etc. via a network.
Action to be taken upon an event occurrence
When the recorder recognizes an event, it will take an event action according to the set action mode.
Refer to the "Event action mode" (
☞
Page 123) for further information about the event action and action mode.
The actions that can be set up and checked from a PC when an event occurs are described below.
Display the alarm message
A window that notifies of an event occurrence will be displayed.
Click the [OK] button or the [×] button to close the window. When several events occur at the same time, the
information for the event that occurred last will be displayed. When you check "Do not display this message
again", the alarm message will not be displayed until the web browser is restarted even if an event occurs.
Display the alarm button
The [ALM] button will be displayed in the status display area. The alarm action will be canceled by clicking
[ALM] button. (
☞
Display the error button
The [ERR] button will be displayed in the status
display area. The error action will be canceled by
clicking [ERR] button. (
☞
[Operation via PC web browser]
