![background image](http://html1.mh-extra.com/html/hyundai/99999-hm5065a/99999-hm5065a_installation-instructions-manual_2195897009.webp)
3. INSTALLATION PROCEDURE
1)
Position the transit fuse into
operational Mode. This fuse is located
in the cabin fuse box, and may be
accessed via the access door in the
drivers’ side ‘knee block pocket’.
45mm
2) Remove the radio blanking plate by
carefully inserting a thin flat
screwdriver 45mm inwards from the top
edge of the blanking plate and gently
levering.
(See photo)
Note:
To avoid damaging the centre Facia
panel during blanking plate removal. Please
insert a small piece of cardboard (as shown)
to protect the facia while levering.
3) Disconnect the attached wiring harness
and aerial connector from the rear of
the blanking plate.
(See photo)
4)
Remove the adhesive backing from the
foam insulator strip (supplied with the
audio unit), and affix this insulator strip
to lower section (at the front) of the
install sleeve as shown.
(See photo)
5) Connect the HM5065 wiring harness
connector to the vehicle wiring
connector.
Foam Insulator
•
Check that the 1-amp fuse is secure in
the fuse holder of the HM5065
harness.
•
Check that all leads are firmly affixed
into the plug of the HM5065 harness,
except for the pink ‘telephone mute’
wire, which does not need to be
connected.
6) Connect the aerial and HM5065 wiring
harness to the radio, ensuring that the
orange ‘illumination’ wire from the
audio unit rear is connected to the
‘female’ orange wire in the HM5065
harness.
Foam
Glove box
stoppers
7) To provide easier installation, lower the
glove box by removing the stoppers, on
either side of the glove
box door, and
reposition the audio unit wiring harness
from the rear.
8) Insert the radio into the install sleeve.
Do not
push the radio all the way into
the locking position at this stage.
9