(4)
Retract cup holder by 75%. Remove the 2-cup
holder affixing screws.
(See photo)
(5) Remove centre facia by using pressure with
fingers from the bottom of the facia.
(See
photo)
.
(6) Disconnect the wiring connectors from the controls behind the facia for -
Clock
Fog light
Rear demister
Hazard lamp
Fan speed
(7) Tilt facia forward sufficiently to gain access to
audio installation sleeve. Note: Care must be
taken not scratch the facia panel.
(8)
Remove the two locking screws each side of
the audio install sleeve.
(See photo)
Remove and reposition the sleeve as
required
.
NOTE:
Confirm that the rear of the audio sleeve is mounted in line (parallel) with
the support bracket behind the sleeve. (It may be that the sleeve has been
positioned under this bracket in error.)
Ensure both left and right hand wings are correctly located against the dash
Re-insert and secure the screws to ensure best fit.
Re-install centre facia and control cables in the reverse order. Be sure to
check for correct operation of all mode control positions eg: face, feet, demist
etc.
Re-install radio.
31