3) Remove the radio blanking plate, by
carefully inserting a thin flat blade
screwdriver, 45mm inwards from the
top edge of the plate on both sides.
(See photo above).
45mm
Insert the screwdriver 45mm inwards from the
top edge, on both sides and remove blanking
plate with your fingers.
NOTE
- Avoid damaging the upper center
Facia.
4) Disconnect the wiring harness and
aerial connector from the rear of the
blanking plate.
(See photo).
Discard the
blanking plate.
5) Insert the supplied foam strip onto the
bottom surface of the radio sleeve.
Ensure the gap between the strip and
the cradle is even on both sides of the
foam strip. Firmly press down on the
strip.
(See photo).
Connect the HM5064 radio wiring harness as
shown.
Ensure both gaps are
even
6) Connect the HM5065A wiring harness
connector to the vehicle connector.
(See photo).
a) Check that the fuse is secure in
the fuse holder.
b) Check that all leads are affixed
into both plugs of HM5065A
harness except the telephone
mute cable.
7) Connect the aerial and wiring harness
to the radio.
15
8)
Position the radio on an angle and
gently insert the radio into the install
sleeve.
Be sure the radio sits over the foam
strip. Ensure the strip is not pulled off
the sleeve to confirm that all controls