3) Remove the radio blanking plate, by
carefully inserting a thin flat blade
screwdriver, 45mm inwards from the top
edge of the plate on both sides.
(See
photo above).
NOTE
- Avoid damaging the upper center Facia
45mm
Insert the screwdriver 45mm inwards from the
top edge, on both sides and remove blanking
plate with your fingers.
4)
Disconnect the attached wiring harness
and aerial connector from the rear of the
blanking plate.
(See photo).
Discard the attached wiring harness and
blanking plate. They are not required
5)
Connect the HM5065A wiring harness
connector to the vehicle connector.
(See
photo).
a. Check that the fuse is secure in the
fuse holder.
b. Check that all leads are affixed into
both plugs of HM5065A harness
except the telephone mute cable.
6.
Connect the aerial and wiring harness to
the radio.
Connect the HM5064 radio wiring harness as
shown.
7.
Insert the radio into the install sleeve.
Do
not
push the radio all the way into the
locking position at this stage.
8.
You now need to confirm that all controls
are operational.
9.
The Anti-Theft security code needs be
entered.
ANTI-THEFT SECURITY CODE INPUT
27