Humminbird MEGA Live, Manual

Page: 36 / 75

30 MEGA 360 Installation
4. Adjust the Pod Height
1. Deploy the Trolling Motor.
2. Loosen the socket bolts on the mount where the pod shaft is installed. Adjust the
pod shaft up or down, so it meets the following height requirements:
• The pod must be mounted approximately 6" (152.4 mm) below the waterline.
• The pod must be mounted at least 1" (25.4 mm) off the tip of the propeller.
• The pod shaft needs to protrude at least 1" to 2" (25.4 mm to 50.8 mm) above
the bracket when it is installed.
WARNING! DO NOT INSTALL THE POD TOO CLOSE TO THE PROPELLER. If the pod
is installed too close to the propeller, it will be damaged. Ensure there is at least 1" of
clearance between the pod and the propeller. MEGA 360 damage caused by the pod being
installed too close to the trolling motor’s propeller is
NOT covered by the product warranty.
1" (25.4 mm)
minimum shaft length
above bracket
1" (25.4 mm)
minimum
between pod
and propeller
Adjusting the Pod Height (at least 1" from the tip of the propeller)