Humminbird MEGA Live, Manual

Page: 26 / 75

20 MEGA Live Installation
8. Install the MEGA Live TargetLock Heading Sensor
1. Slide the heading collar over the cables and shaft and align the holes in the
collar with the holes at the top of the shaft.
NOTE: Align the heading collar so that the raised section faces away from
the MEGA Live transducer’s pinging element (instead of towards it) to ensure
the arrow on the TargetLock heading sensor will point in the same direction as
the MEGA Live.
2. Feed the TargetLock heading sensor cable through the heading mount and
position the sensor on the mount so that the arrow on the sensor points away
from the gap in the mount.
3. With the gap in the mount aligned with the raised section of the heading collar,
slide the mount over the transducer cables and collar so that the transducer
cables and TargetLock heading sensor cable exit the mount through the gap.
NOTE: The cables should be aligned so that the heading sensor cables in
stacked on top of the MEGA Live power and ethernet cables.
4. Secure the heading collar and mount to the shaft with the included #8-32x2
screw and hex key (see the illustration Connecting the Heading Collar and
Mount ).
NOTE: You may need to adjust the positioning of the cables to make room for
the screw.
5. Secure the TargetLock heading sensor to the mount with the included two (2)
#8-32x7/8 screws.