Humminbird MEGA Live, Manual

Page: 19 / 75

13 MEGA Live Installation
5. Install the Landscape Mode Mount
Use the following instructions to install the
Landscape Mode mount onto the shaft mount and
the transducer.
1. The Landscape Mode mount should be open
for this step of the installation. Unlock the
mount by pressing down on the two release
buttons and pulling the mount open. It will
relock automatically once fully opened.
2. With the Landscape Mode mount hinge perpendicular to the shaft, connect the
Landscape Mode mount to the shaft mount (see the illustration Connecting
the Landscape Mode Mount to the Shaft Mount ).
The ratchets on the Landscape Mode mount hinge and the shaft mount are
keyed to ensure correct alignment.
Connecting the Landscape Mode
Mount to the Shaft Mount
3. Secure the Landscape Mode mount to the shaft mount with one of the
included lock washers and 1/4-28 screws, using the provided hex bit. Hand
tighten the screw until the lock washer is fully compressed (see the illustration
Compressing the Lock Washer ), and then tighten an additional 1/4 turn.
Hand tighten only!
WARNING! The screw and lock washer MUST be fully tightened. Failure to
do so may result in the transducer detaching from the shaft mount in the water.
release
buttons
Landscape Mode Mount