Humminbird MEGA Live, Manual

Page: 46 / 75

40 Cable Installation
3. Route the MEGA 360 Cables
(separate purchase)
1. Connect the power cable to the power cable connector on the pod shaft, and
connect the transducer cable to the transducer cable connector on the pod
shaft.
The connectors are keyed to prevent reversed installation, so be careful not to
force the connectors. Hand-tighten the screw nuts on each connector.
NOTE: If you are connecting the MEGA 360 Imaging transducer and
another compatible transducer to the same control head, you will need to
purchase a transducer splitter cable (y-cable). See
Compatibility for the list
of cables, and visit our Web site at www.humminbird.com/support/
installation-diagrams to view the wiring diagrams.
2. Route the cables to the side of the trolling motor, over the bow, to the chosen
connection locations in Section 1: Prepare for Installation . Leave sufficient
slack in the cables to allow for full movement of the trolling motor during
normal operation.
3. APEX/SOLIX: Insert the other end of the
transducer cable to the sonar port on the control
head. Hand-tighten the screw nut.
HELIX: Insert the transducer adapter cable to the
transducer port on the HELIX control head.
HELIX G3N 8, 9, 10, 12 Cable Tray
Ethernet temp/speed pin pin
power COM (communications) transducer
APEX/SOLIX Sonar Port