Humminbird MEGA Live, Manual

Page: 38 / 75

32 MEGA 360 Installation
5. Install the Collar Clamp
After you have established the pod height is no closer than 1 inch from the tip of
the propeller, install the collar clamp to prevent the trolling motor from hitting the
transducer pod.
1. Apply anti-seize to the end of each 1" socket bolt (1/4-20 x 1").
2. Install a 1" socket bolt (1/4-20 x 1") into the hole on 1 clamp half.
3. Place the bumper into the groove of the trolling motor shaft. Center one clamp
half over the bumper as shown in the illustration.
4. Install a washer, the clamp (half), and hex nut (1/4-20) onto the trolling motor
shaft as shown in the illustration. Repeat on the other side.
nut
Installing the Collar Clamp
clamp
clamp
bumper
groove in trolling
motor shaft
washer
socket bolt
(1/4 - 20 x 1")
NOTE: If your installation kit does not include a washer, you may skip the
washer portion of the installation.