Humminbird MEGA Live, Manual

Page: 28 / 75

22 MEGA Live Installation
9. Adjust the Transducer Height
1. Loosen the depth collar knobs and adjust the transducer shaft up or down so
that it meets the following height requirements in all three views (see Install
the MEGA Live Imaging TargetLock, Section 5: Test the MEGA Live Views ):
• The transducer must be mounted approximately 6" (152.4 mm) below the waterline.
• The transducer must be mounted at least 1" (25.4 mm) off the tip of the propeller.
WARNING! DO NOT INSTALL THE TRANSDUCER TOO CLOSE TO THE PROPELLER.
If the transducer is installed too close to the propeller, it will be damaged. Ensure there
is at least 1" of clearance between the transducer and the propeller. MEGA Live damage
caused by the transducer being installed too close to the trolling motor’s propeller is NOT
covered by the product warranty.
2. Slide the bottom depth collar to the desired position, and tighten the knob to
secure the depth collar in place so the transducer shaft is fully secure and won’t
drop during operation.
3. Slide the top depth collar down to secure the transducer shaft to the desired
height, and tighten the knob to secure the depth collar in place.
Securing the Depth Collars
depth collar
depth collar