Hughes HX200, Installation Manual

Page: 85 / 160

Chapter 5 • The System Control Center
1038054-0001 Revision B
75
21 The transmitter is disabled because a transmit
pointing test failed Occurs when the transmitter fails a transmit pointing
test, thereby indicating that the transmitter did not
meet the minimum specifications required. This is
likely due to an antenna installation problem.
Fine-point the antenna. The transmitter will not
transmit until the transmit pointing test passes.
22 The transmitter is disabled pending a transmit
pointing test Occurs when the transmitter is unable to perform a
periodic background transmit pointing test within the
allotted time frame. The transmitter is expected to be
in this condition at random periodic intervals for no
more than two minutes at a time. This condition can
also occur after the transmitter is first powered on
after it has been powered off for more than a 24
hours. If this condition persists for more than two
minutes, it is likely that the automated transmit
pointing components in the system gateway are
experiencing problems. This condition should clear
in a few minutes.
23 The transmitter is disabled because a transmit
pointing test cannot be performed Occurs when the transmitter cannot perform a
transmit pointing test during initial installation or
when ranging. Ranging is the automated process of
adjusting the satellite transmitter timing and power.
The satellite transmitter performs ranging as
necessary to ensure that it can communicate
successfully with the system gateway. The condition
indicates that the system gateway components
required to perform the transmit pointing test are not
operational.
24 The transmit cable is disconnected Indicates that the satellite router unit cannot detect
the transmit cable connection. Ensure that the
transmit cable is securely attached to the satellite
router unit and to the transmitter on the antenna
assembly. (See the Caution statement that follows
Figure 2 on page 13.) Inspect the transmit cable and
the antenna assembly to make sure that they are not
damaged.
25 Uplink reset is in progress This is a transitional state and requires no
interaction. If the problem persists, contact
Technical Support.
26 No inroute groups support Closed Loop timing Indicates a problem at the HX System Gateway. If
the problem persists, contact Technical Support.
Table 8: Transmit code (TxCode) messages and corrective actions (Continued)
Code Message Corrective actions