Hughes HX200, Installation Manual

Page: 79 / 160

Chapter 5 • The System Control Center
1038054-0001 Revision B
69
5 The receiver is operational Normal operating state for the receiver. Indicates
that data is being received from the system gateway.
The transmitter will only operate correctly when the
receiver is in this state.
6 The receiver is not detecting a signal Occurs when the unit is not detecting a radio signal
from the antenna. May indicate a faulty receiver or
faulty cabling between the receiver and the antenna.
Check that the cables are firmly connected to the
satellite router. (See the Caution statement that
follows Figure 2 on page 13.) If this condition
persists, power-cycle the satellite router by turning
the unit off, waiting 15 seconds, and turning it back
on.
7 The receiver is locked to an unknown network Should only occur during installation or when the
receiver is locked to a non-system satellite. In rare
cases, may also be due to a transient outage at the
system gateway. If this condition occurs during
pointing or commissioning, the antenna has not
been pointed correctly. If it occurs during normal
operation, could indicate a change in satellite
parameters, or that the antenna has become
misaligned. If the satellite parameters have been
changed, re-commission the site. Otherwise, repoint
the antenna.
Table 7: Receive code (RxCode) messages and corrective actions (Continued)
Code Message Corrective actions