Hughes HX200, Installation Manual

Page: 44 / 160

Chapter 3 • Commissioning the HX200 satellite router
34
1038054-0001 Revision B
NOC override In some cases the NOC may need to override the allowed inroute
symbol rates mask due to the installer’s selection. In order to
override the selection from the NOC, the following parameter
must be set in the satellite router’s InrouteProfile:
shinrtCfLocalInrtMaskOverride=2
As a result of the NOC override, the satellite router uses the
inroute rates specified by the NOC instead of the transmit radio
selection.
Error checks The Javascript Form Check is used on all relevant fields in the
Manual Commissioning interface. If the installer enters an
incorrect value for any field, an error message displays and the
form cannot be submitted until the error is corrected.
Antenna pointing
Follow these steps to use the Antenna Pointing feature on the
HX200 web-based interface to peak the receive and transmit
signals:
1. Turn off the HX200 using the power switch on the rear panel.
2. Connect the receive and transmit coaxial cables to the
HX200.
3. Place the DAPT in the receive cable line, if applicable.
4. Apply power to the HX200.
5. Open a web browser on the installer laptop and navigate to
the Broadband Satellite Setup screen as explained in
Accessing the manual commissioning interface on page 22.