Hughes HX200, Installation Manual

Page: 127 / 160

Appendix B • Updating the satellite router software
1038054-0001 Revision B
117
7. Select
Use the following IP address
.
8. Type
192.168.0.2
in the
IP address
field.
9. Type
255.255.255.252
in the
Subnet mask
field.
10. Click OK .
11. Restart the computer even if Windows does not require you to
do so. This ensures that the network settings are
automatically reset.
Updating the
fallback.bin file Follow the steps below to update the
fallback.bin
file. During
this process, the files containing the current software release are
transferred to the satellite router, overwriting the older files.
1. Confirm that the installer laptop Ethernet cable is connected
to the HX200 satellite router by performing a ping test:
a. Open a DOS command line prompt or Command window
on the installer laptop.
b. Type
ping 192.168.0.1
.
c. Press E
NTER
.
Continue with step 2 if the ping test is successful. Refer to
Troubleshooting the update on page 119 if the ping test fails.
2. Navigate to the location on the laptop where you saved the
Fallback Updater utility and its supporting files in Step 4 of
Saving the utility on the installer laptop on page 111.
3. Launch the Fallback Updater utility by opening the
HX_Updater.exe
file.
4. Type
192.168.0.1
in the IP address field on the System
Updater window as shown in Figure 73. This value is the
HX200 IP address.
5. Click OK .
During the update process, status messages will appear in the
message window between the address field and the
OK button.
Note: You do not need to enter information in the
Default
gateway
,
Preferred DNS server
, or
Alternate DNS server
fields.
Figure 73: Entering the satellite router IP address